ADIC DLT 7000 Especificaciones descargar pdf (Pagina 27)

Operation and Maintenance 17

2. The LEDs on the left front panel of the drive will turn ON at the same time for about three seconds and

then turn OFF.

3. The Operate Handle, Write Protected, and Use Cleaning Tape LEDs will turn OFF. The Tape

in Use LED will blink while the tape drive initializes.

4 If your external SCSI bus terminator(s) have a Term Power LED it should also be illuminated.

Drive Status

After completion of the drive POST and initialization, each drive will be in one of the four states listed in the

following table:

Drive State Indicator Displays and Actions

1. No cartridge is present

A. The Tape in Use LED turns OFF.

B. The Operate Handle LED turns ON.

C. The handle is unlatched.

D. The drive beeps momentarily.

2. A cartridge is present

and the handle is closed.

The drive loads the cartridge. When the Tape in Use LED stops

blinking and stays ON, the tape’s actual density lights. For example, if

the actual tape density is 2.6, then the LED turns ON next to the 2.6

label. When the Density Override LED blinks, you can select a

density. The drive is ready for use.

3. A cartridge is present,

but the handle is open.

The Tape in Use LED turns OFF. The Operate Handle LED

flashes. When the Tape in Use LED stops blinking and stays ON, the

tape’s actual density lights. For example, if the actual tape density is

2.6, then the LED turns ON next to the 2.6 label. When the Density

Override LED blinks, you can select a density. The drive is ready for

use.

4. The drive detects an

error condition.

Then all right or left side LEDs blink repeatedly. You may try to

unload the tape and reinitialize the drive by pressing the Unload key

or turn power OFF and then ON again. The right or left side LEDs stop

blinking and the drive tries to reinitialize. The LEDs turn ON steadily

again and then turn OFF if the test succeeds.

The drive POST completes in about 13 seconds on each drive, and the drives will respond normally to all

commands. However, it may take longer for the media to become ready.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 45 46

Sin comentarios

ADIC DLT 7000 Especificaciones Pagina 27