ADIC DLT 7000 Especificaciones descargar pdf (Pagina 20)

10 Installation

SCSI Terminators

External SCSI bus terminators should be used with either single-ended or differential drive configurations.

1. Install any required external terminator(s) on the appropriate SCSI connector(s) on the rear panel of

your T5 Enclosure.

Note

A drive should only be terminated if it is the last physical device on a SCSI bus.

SCSI ID Selection Switches

The SCSI ID selection switches are located at the top, near the center of the T5 rear panel. Each switch has

sixteen positions (0 through 15) and the selected ID is shown in the switch window.

1. To select a higher SCSI ID, push the “+” button. To select a lower SCSI ID, push the “-” button.

Notes

• Each device attached to an individual SCSI channel must be assigned a

unique SCSI ID.

• SCSI IDs are preset at the factory to the following: Drive 1 = 1, Drive 2 = 2,

Drive 3 = 3, Drive 4 = 4, Drive 5 = 5.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 45 46

Sin comentarios

ADIC DLT 7000 Especificaciones Pagina 20